|
- Rugged, compact design
- 8 module slots
- 9th port for remote module
- 10 MHz reference with external sync
- Cascade multiple mainframes
- GPIB and RS-232 interfaces
- Start-up script memory
Datasheet
|
|
- 4 nV/√Hz input noise (SIM910)
- 1.8 nV/√Hz input noise (SIM911)
- Low output noise
- 1 MHz bandwidth
- Selectable gain from 1 to 100
- AC or DC coupled
- Differential or single-ended input
- 85 dB CMRR
- Remote interface
Datasheet
|
|
SIM914 - 350 MHz preamplifier
- DC to 350 MHz bandwidth
- Two independent amplifier channels
- Voltage gain of 5 (14 dB) per channel
- 6.4 nV/√Hz input noise
- 3 ns overload recovery
- Excellent phase linearity
Datasheet
|
|
SIM918 — Current preamplifier with autozero feature
- Input offset voltage <10 µV
- DC bias current <2 pA
- Current gain of 106 to 108
V/A
- 15 fA/√ Hz input noise (108
V/A)
- Autozero feature
- Bias voltage input
Datasheet
|
|
SIM921 — AC resistance bridge for millikelvin
thermometry
- Accurate millikelvin thermometry
- Microvolt/picoamp excitation
- Measurements from 1 mΩ to 100 MΩ
- Variable excitation from 2 Hz to 60 Hz
- Linearized analog output
- Resistance, temperature and phase
Datasheet
|
|
SIM922 and SIM923 — Diode & Pt RTD
temperature monitors
- Four channels with independent displays
- 1.4 K to 475 K with silicon diodes
- 20 K to 873 K with platinum RTDs
- Memory for 4 calibration curves plus standard curve
Datasheet
|
|
SIM922A & SIM923A — Diode and Pt RTD
temperature monitors & SIM923A — Diode und Pt RTD Temperaturüberwacher<
- Single-channel LED display
- 1.4 K to 475 K with Si, GaAs or GaAlAs diodes
- 1.4 K to 873 K with RTDs
- Two analog outputs:
- Linearized V proportional to T
- Sensor voltage (buffered)
- Remote interface
Datasheet
|
|
|
SIM925 — 4-pole relay
switching multiplexer (8 ch.)
- Eight input channels
- Four-pole relay switching
- Selectable buffer for V-sense lines
- Rear-panel bypass for unlimited daisy-chaining
Datasheet
|
|
|
SIM928 — Rechargeable
isolated voltage source
- ±20 V isolated voltage source
- Ultra-low noise output
- Two switchable, recharging batteries for continuous operation
- Battery lifetime: 1000 charge cycles
- Output floats to ±40 V
- Short-circuit protected
Datasheet
|
|
|
SIM940 — 10 MHz rubidium
oscillator
- Three 10 MHz outputs
- 1 pps input and output for GPS synchronization
- 20 year aging less than 0.005 ppm
- Ultra-low phase noise (<-130 dBc/Hz at 10 Hz)
- Remote interface
Datasheet
|
|
|
SIM954 — 300 MHz
dual-channel inverting amplifier
- DC bis 300 MHz Bandbreite
- ±10 V Ausgangsspannung
- Bis zu 1 A Ausgangsstrom
- <1 dB Flachheit
- 4000 V/µs Anstiegszeit
- 2 unabhängige Kanäle
Datasheet
|
|
|
SIM960 — 100 kHz analog PID controller
- Analog signal path with digital control
- 100 kHz bandwidth
- Low-noise front end
- P, I, D and Offset settable to 0.5 %
- Anti-windup (fast saturation recovery)
- Bumpless transfer, manual to PID
- Analog setpoint with smooth ramping
- Smooth upper/lower limit clamping
Datasheet
|
|
|
SIM964 — 1 MHz limiter
- Settable upper & lower limits (±10 V)
- 10 mV resolution
- 1 MHz bandwidth
- TTL outputs for limit detecting
- High slew rate
Datasheet
|
|
|
SIM965 — Analog high-pass /
low-pass filter
- Bessel and Butterworth filter types
- 1 Hz to 500 kHz
- 3-digit cutoff frequency resolution
- High-pass or low-pass operation
- Selectable rolloff
- Continuous time (not sampled)
Datasheet
|
|
|
SIM970 — 5½-digit
voltmeter (4 ch.)
- True 5½-digit performance
- Four isolated channels
- Bright 7-segment LED displays
- Three decade autoranging to ±19.9999 V
- 10 MΩ input impedance
- External trigger for data synchronization
- Unique continuous autocalibration
- 90 dB power line frequency rejection
Datasheet
|
|
|
SIM980 — Four channel
summing amplifier
- Four summing inputs
- ±10 V operating range
- 1 MHz bandwidth
- Low crosstalk (−80 dB)
- <100 µV input offset
- High slew rate
Datasheet
|
|
|
SIM983 — Analog scaling amplifier
- Adjustable gain and offset
- 3½-digit resolution
- 1 MHz bandwidth
- Low-noise input
- ±10 V operating range
Datasheet
|